4SE - tool 2.0.4 Selected model: W900
Selected operation: Unlock
Selected interface: UART (BOOTROM)
Remove battery, wait a few seconds and insert it back
Connect cable and press "Power" button shortly
Connected to COM7
You can now release the keys and allow the process to run. Do not disconnect the phone
Device identification...OK
Sending Preloader...OK
Starting GDFS service...OK
Reading GDFS security data...OK
Chip:DB2000 Model:W900i IMEI:35785800-138802-4 CID:49 Domain:RED
OTP LOCKED:1 CID:49 PAF:1
Uploading logic DB2000:
Detecting flash type...OK
ID: 890D (Intel)
Chip: Intel Tyax 256 Mbit NOR (top boot)
Logical address: 0x20000000
Size: 32 Mb
Shutting down device...OK
Remove battery, wait a few seconds and insert it back
Connect cable and press "Power" button shortly
Connected to COM7
You can now release the keys and allow the process to run. Do not disconnect the phone
Device identification...OK
Uploading logic DB2000:
Sending ResetLoader...OK
Authenticating with key KIDP96200133...OK
Reseting to factory defaults...OK
Shutting down device...OK
Remove battery, wait a few seconds and insert it back
Connect cable and press "Power" button shortly
Connected to COM7
You can now release the keys and allow the process to run. Do not disconnect the phone
Device identification...OK
Uploading logic DB2000:
Sending ProductionLoader...OK
Writing EROM...OK
Writing SIMLock data...OK
Shutting down device...OK
Remove battery, wait a few seconds and insert it back
Connect cable and press "Power" button shortly
Connected to COM7
You can now release the keys and allow the process to run. Do not disconnect the phone
Device identification...OK
Uploading logic DB2000:
Sending ProductionLoader...OK
Changing certificate to A1_DB2000_49_RED...OK
Shutting down device...OK
Operation completed successfully. You can disconnect the phone now
FINISHED [76sec]
المفضلات